Internals For Structured PackingINTERNAL FOR REGULAR PACKINGS
Metal
You can see detailed explanation if you hover the mouse over an arrow of the tower.
MC distributor
Support grid
Wall wiper
Collector
MC distributor
Column Internals which disperse equally liquid on face of packing.
MC distributor can uniformly get packing wet by the groundbreaking number of drip points(More than 1000/m3） and can bring out ability of packing at full.
Support grid
Column Internals for supporting packing.
Wall wiper
Parts in column for collecting liquid flowing down on a wall to the center of column.
Collector
Parts in column which liquid flowing down from the upper packing layer is collected to the distributor by.
MC distributor
MC distributor Water dispersion test.
NOZZLE OVERFLOW TYPE
- A hole is located on the upper surface of a pipe, through which a liquid flows out. It prevents an absence of liquid and helps maintain the constant
volume of flow under extremely low load.
- A diffuser plate and clicks on a lower side allow a liquid to spread more through a groundbreaking number of drip points.
- A thin film of a reflux flow flowing over the diffuser plate is in a direct contact with steam nearby, so that the temperature rises up to a boiling point.
| Type |
Manageable range
of liquid amount |
Variable range of
liquid amount |
Drip point |
Aperture ratio |
| Nozzle Overflow Type |
MIN 50 l／m²H
MAX 80m³／m²H |
1～10 |
1000～2000 point／m² |
50～70% |
OPEN TROUGH TYPE
- Notches on the upper side are sloping to divide the outflow liquid.
- A diffuser plate and clicks on a lower side allow a liquid to spread more through a groundbreaking number of drip points.
- Nozzle overflow type is suitable for a liquid that may block a hole.
| Type |
Manageable range
of liquid amount |
Variable range of
liquid amount |
Drip point |
Aperture ratio |
| Open Trough Type |
MIN 200l／m²H
MAX 80m³／m²H |
1～5 |
1000～2000 point／m² |
50～70% |
